VW Polo manuals

Volkswagen Polo Owners Manual: Warning lamp

First read and observe the introductory information and safety warnings

Lit up Possible cause Solution
At least one vehicle door is opened or not properly closed. Do not drive on!
Open the appropriate vehicle door and then close it again.

Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

A warning lamp appears in the instrument cluster display if a door is open or not properly closed.

Introduction
This chapter contains information on the following subjects:  → Warning lamp  → Childproof lock Additional information and warnings: Exterior views Vehicle key set ...

Childproof lock
Fig. 27 In the left rear door: childproof lock Ⓐ switched off, Ⓑ switched on Fig. 28 In the right rear door: childproof lock Ⓐ switched off, Ⓑ switched on First read and observe the in ...

Other materials:

Evaporator Vent Temperature Sensor -G263- or Evaporator Temperature Sensor -G308
Function: The Evaporator Vent Temperature Sensor -G263- or Evaporator Temperature Sensor -G308- determines the temperature behind the evaporator. This value goes to the air conditioning control module and serves as a reference signal for ...

Evacuating and Charging Valve, High Pressure Side
Special tools and workshop equipment required Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench 1783 - 1/4" Drive Ratchet -VAS6234-   WARNING There is a dan ...

Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing
Overview, Beru System   WARNING If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.   WA ...

© 2016-2020 Copyright www.vwpolo.net