Volkswagen Polo Owners Manual: Securing child seats with a seat belt

Volkswagen Polo Owners Manual / Sitting correctly and safely / Child seats (accessories) / Securing child seats with a seat belt

First read and observe the introductory information and safety warnings

It is permissible to fasten child seats with universal written on the orange label to the seats using the seat belt, but only on the seats marked in the table with a u.

Weight class	Front passenger seat	Seats on the rear bench seat
Group 0 up to 10 kg	u	u
Group 0+ up to 13 kg	u	u
Group 1 9 to 18 kg	u	u
Group 2 15 to 25 kg	u	u
Group 3 22 to 36 kg	u	u

Securing a child seat using the seat belt

Read and follow the child seat manufacturer's instructions.

When placing the child seat on the front passenger seat, push the seat back as far as possible and adjust the backrest to an upright position .

Position the child seat on the seat according to the instructions given by the child seat manufacturer.

The seat belt height adjuster must be at the highest setting.

Fasten the seat belt or guide it through the child seat as described in the child seat manufacturer's instructions.

Ensure that the seat belt is not twisted.

Insert the latch plate into the buckle for the appropriate seat and push it down until it locks securely with a click.

In vehicles with lockable seat belts: pull the shoulder part of the belt all the way out and let the belt web roll up on the automatic belt retractor. The belt makes a clicking sound as it rolls up.

The upper part of the belt must lie snugly and fully over the child seat.

Pull the seat belt to check that the lower belt strap is locked and can no longer be pulled out.

In vehicles with lockable seat belts: secure any seat belts that are not being used out of the reach of the child in the child seat, by guiding the belt behind the head restraint on the neighbouring seat. When doing this, make sure that the locking mechanism of the seat belt is not triggered! The belt should not make a clicking sound as it rolls up. Let the belt web roll up on the automatic belt retractor.

Removing child seats

Unfasten seat belts only when the vehicle is stationary .

Press the red button in the buckle. The latch plate is released and springs out.

Guide the belt back by hand so that it rolls up easily, without twisting the seat belt and without damaging the trim.

Remove the child seat from the vehicle.

WARNING

Unfastening seat belts while the vehicle is in motion can lead to severe or fatal injuries in the event of an accident or sudden braking or steering manoeuvre.

Unfasten seat belts only when the vehicle is stationary.

Using a child seat on the rear seats

First read and observe the introductory information and safety warnings When fitting a child seat to a rear seat, the position of the front seat must be adjusted to ensure that the child has suff ...

Attaching child seat with lower anchoring points (ISOFIX)

Fig. 64 On vehicle seat: different markings identifying the lower anchoring points for child seats First read and observe the introductory information and safety warnings 2 retaining rings, als ...

Other materials:

Laws and Regulations
Note The laws and regulations listed below are applicable in Germany. Different or additional laws and regulations may apply in other countries. Addresses in other countries can be obtained from the relevant au ...

Refresh Charging with Battery Charger -VAS5903
Special tools and workshop equipment required Battery Charger -VAS5900- WARNING Risk of injury. Follow all Warnings and Safety Precautions. Refer to → ...

Refrigerant Circuit, Tracing Leaks, with Electronic Leak Detector -VAG1796
Note This repair manual describes different methods for detecting leaks in the refrigerant circuit. These methods have been tested and result in success when used correctly. If when searching for compressed air / Nit ...