Volkswagen Polo Owners Manual: Roll-back function for the electric windows
First read and observe the introductory information
and safety warnings
The roll-back function for the electric windows can reduce the risk of injuries
when the windows are closing . If the one-touch closing function for a window does
not work because it is stiff or is being obstructed, the window will automatically
open again.
- Check to see why the window has not closed.
- Try to close the window again.
- If the window is again prevented from closing within approximately 10 seconds
of the first attempt because it is stiff or obstructed, the automatic closing
function is switched off for approximately 10 seconds.
- If the window is still obstructed, the window stops at this point. To close
the window without the roll-back function, press the button
again within 10 seconds .
Closing the window without the roll-back function
- Try to close the window again within approximately 10 seconds by holding
the button. The roll-back function will be deactivated for a small section
of the path of the closing window.
- If the closing procedure takes longer than approximately 10 seconds, the
roll-back function will be reactivated. The window will then stop again if it
is stiff or meets another obstacle.
- Please go to a qualified workshop if the window still cannot be closed.

WARNING
Closing the electric windows without the roll-back function could lead to severe
injuries.
- Always take care when closing electric windows.
- Ensure that nobody obstructs the path of the electric windows, especially
if the roll-back function is not active.
- The roll-back function does not prevent fingers or other body parts from
being pressed against the window frame and sustaining injury.
The roll-back function is also activated if the windows are closed using the
vehicle key for convenience closing .
First read and observe the introductory information
and safety warnings
One-touch opening and closing
One-touch opening and closing makes it possible to fully open and close the windows.
The ind ...
Other materials:
Warning and indicator lamps
The warning and indicator lamps indicate various warnings , faults or certain
functions. Some warning and indicator lamps light up when the ignition is
switched on and should go out once the engine is running or the vehicle is in
motion.
Depending on the vehicle's equipment level, additional ...
Taper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
Ignition lock
Fig. 107 Positions of the vehicle key in
the ignition lock
First read and observe the introductory information
and safety warnings The steering lock can be activated when
there is no vehicle key in the ignition lock.
Vehicle key positions
Ignition switched off. The vehicle key ca ...
© 2016-2025 Copyright www.vwpolo.net
