VW Polo manuals

Volkswagen Polo Owners Manual: Preparing the vehicle for working in the engine compartment

Volkswagen Polo Owners Manual / In the engine compartment / Preparation for working in the engine compartment / Preparing the vehicle for working in the engine compartment

First read and observe the introductory information and safety warnings

Introduction
This chapter contains information on the following subjects:  → Preparing the vehicle for working in the engine compartment  → Opening and closing the bonnet Always park the vehicle ...

Checklist
The following steps should always be carried out in the specified order before working in the engine compartment : Park the vehicle on a level and stable surface. Depress and hold the bra ...

Other materials:

Reinforced Shock Absorbers and Coil Springs
Reinforced shock absorbers and coil springs on the vehicle rear axle reduce pitching motions between the vehicle and the trailer. If not already installed in the factory, these shock absorbers and springs can often be retrofitted at authorized Volk ...

Two-Part HS Hardener
Definition: Two-Part HS Hardener -LHA 009 041 A3- Two-Part HS Hardener, Short -LHA 021 004 A3- Two-Part HS Hardener, Extra Short -LHA 009 046 A2- Two-Part HS Hard ...

Valve, Removing and Installing, Rubber Valve
Make sure wheel rim is clean.     –  Using the Valve Fitting Tool Valve Fitting Tool -VAS6459--1-, insert a new tire valve. –  Remove the valve insert. ...

© 2016-2026 Copyright www.vwpolo.net