Volkswagen Polo Owners Manual: Introduction

Volkswagen Polo Owners Manual / Hubcaps / Introduction

This chapter contains information on the following subjects:

→ Wheel cover
→ Wheel bolt caps

Additional information and warnings:

Tyre monitoring system

Cleaning and caring for the vehicle exterior

Vehicle toolkit

Changing a wheel

Breakdown set

WARNING

Using unsuitable hubcaps, or fitting them incorrectly, can cause accidents and serious injuries.

Incorrectly fitted hubcaps can become loose while the vehicle is in motion and endanger other road users.

Do not use damaged hubcaps.

Always ensure that the airflow to cool the brakes is not restricted or reduced. This also applies if hubcaps are retrofitted. If the airflow is not sufficient, the braking distance could increase significantly.

NOTICE

Remove the hubcaps carefully and fit them again properly so as to avoid damage to the vehicle.

Wheel cover

Fig. 163 Removing press-on wheel covers Fig. 164 Removing bolted-on wheel covers First read and observe the introductory information and safety warnings Removing and fitting press-on wheel ...

Other materials:

Test after driving for 10 minutes
First read and observe the introductory information and safety warnings Reconnect the tyre filler hose and check the tyre pressure on the tyre pressure display ⑥. 1.3 bar (19 psi / 130 kPA) and lower: Do not drive on! The tyre cannot be sealed adequately with the breakdown set. ...

Battery, Charging with Battery Charger -VAS5095A
Special tools and workshop equipment required Battery Charger -VAS5095A- WARNING Risk of injury. Follow all Warnings and Safety Precautions. Refer to → ...

Recycling and Disposal Regulations
Note The laws and regulations listed below are applicable in Germany. Different or additional laws and regulations may apply in other countries. Addresses in other countries can be obtained from the relevant au ...