Volkswagen Polo Owners Manual: Introduction
This chapter contains information on the following subjects:
→ Indicator lamps
→ Catalytic converter
→ Diesel particulate filter
Additional information and warnings:
- Changing gear
- Filling the tank
- Fuel
- Engine oil
- Battery
- Information stored in the control units
- Tow-starting and towing
WARNING
- Park the vehicle so that no part of the exhaust system can come into contact with any inflammable material underneath the vehicle, e.g. dry grass.
- Never apply underseal or anti-corrosion coatings to the exhaust pipes, catalytic converter, diesel particulate filter or the heat shields on the exhaust system.
Indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Engine management syste ...
Other materials:
Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Reinforced Shock Absorbers and Coil Springs
Reinforced shock absorbers and coil springs on the vehicle
rear axle reduce pitching motions between the vehicle and the
trailer. If not already installed in the factory, these shock
absorbers and springs can often be retrofitted at authorized
Volk ...
Warning and indicator lamps
The warning and indicator lamps indicate various warnings , faults or certain
functions. Some warning and indicator lamps light up when the ignition is
switched on and should go out once the engine is running or the vehicle is in
motion.
Depending on the vehicle's equipment level, additional ...
