Volkswagen Polo Owners Manual: Introduction

Volkswagen Polo Owners Manual / Lights and vision / Windscreen wiper and washer / Introduction

This chapter contains information on the following subjects:

→ Indicator lamp
→ Windscreen wiper lever
→ Windscreen wiper functions
→ Service position for the front windscreen wipers
→ Rain/light sensor
→ Checking and refilling the windscreen washer fluid level

Additional information and warnings:

Exterior views

Air recirculation mode

Preparation for working in the engine compartment

Cleaning and caring for the vehicle exterior

WARNING

Without adequate frost protection, the washer fluid can freeze on the windscreen and obscure your view of the road.

In winter temperatures, the windscreen washer system should only be used when adequate frost protection has been added.

Never use the windscreen washer system at winter temperatures before the windscreen has been heated by the ventilation system. This could lead to the anti-freeze mixture freezing on the windscreen and restrict the driver's vision.

WARNING

Worn or dirty windscreen wiper blades reduce visibility and increase the risk of accidents and severe injuries.

Windscreen wiper blades should therefore always be changed if they are damaged or worn and no longer clean the windscreen properly.

NOTICE

In icy conditions, always check that the wiper blades are not frozen to the glass before using the wipers. When parking the vehicle in cold weather, it may be helpful to leave the front windscreen wipers in the service position .

Windscreen wiper and washer

...

Indicator lamp

First read and observe the introductory information and safety warnings Lit up Possible cause Solution Windscreen washer fluid level too low. ...

Other materials:

Checking with Restrictor, Reservoir and A/C Compressor Regulator Valve -N280-, Externally Regulated A/C Compressor
Note Connecting service station. Refer to → Chapter „Connecting Service Station“. Observe test requirements. Refer to → Chapter „Pressures, Checking“. – ...

Indicator lamp
First read and observe the introductory information and safety warnings Lit up Possible cause Cruise control system (CCS) is controlling the speed. Several warning and indicator lamps will light up briefly as a functional check whe ...

CAN Bus Wires, Repairing
Unshielded two-strand wiring -1- and -2- with a cross section of 0.35 mm2 or 0.5 mm2 can be used as CAN bus wiring. The color coding of CAN bus wires can be found in the following table: ...