Volkswagen Polo Owners Manual: Fuses

Test after driving for 10 minutes

First read and observe the introductory information and safety warnings Reconnect the tyre filler hose and check the tyre pressure on the tyre pressure display ⑥. 1.3 bar (19 psi / 130 kPA) a ...

Introduction

This chapter contains information on the following subjects:  → Fuses in the vehicle  → Changing a blown fuse At the time of print we are unable to provide an up-to-date overview of ...

Other materials:

Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must be fulfilled. The tire pressure must be OK. The tire profile must not be worn on one side. The tire profile must be at least 4 mm. ...

Flushing Circuit Block Diagrams
  Note The arrows in the following illustrations show the direction of refrigerant flow while flushing. During flushing, refrigerant flows in the opposite direction than during A/C system operation, therefore the high pressure side of A/C se ...

Waxing and polishing the vehicle
First read and observe the introductory information and safety warningsWaxing Waxing protects the paintwork. You will need to re-wax the vehicle with a good hard wax if water no longer clearly forms small drops and runs off the paintwork when it is clean. Even if a wax solution is used regul ...