Volkswagen Polo Owners Manual: Driving tips when towing
First read and observe the introductory
information and safety warnings
Towing requires some experience, especially when using a tow rope. Both drivers should be familiar with the technique required for towing. Inexperienced drivers should not attempt to tow.
When driving, ensure that you do not pull too hard on the towing vehicle and take care to avoid jerking movements. When towing on an unpaved road, there is always a risk of overloading and damaging the anchorage points.
You can still use the turn signals if your vehicle is towed with the hazard warning lights and ignition switched on. Move the turn signal lever to signal the required direction. The hazard warning lights will not flash while the turn signal is being used. The hazard warning lights will start flashing automatically as soon as the turn signal lever is moved back to the neutral position.
Notes for the driver of the towed vehicle:
- Leave the ignition switched on to prevent the steering wheel from locking, and so that the turn signals, horn, windscreen wipers and washers can be used.
- As the power assisted steering does not work if the engine is not running, you will need more strength to steer than you normally would.
- You will need to depress the brake pedal more vigorously than normal as the brake servo is not working. Do not drive too close to the towing vehicle.
- Read and comply with the information and notes in the owner's manual of the towing vehicle.
Notes for the driver of the towing vehicle
- Accelerate carefully and gently. Avoid any sudden driving manoeuvres.
- Brake earlier than normal by pressing lightly on the brake pedal.
- Read and comply with any information and notes in the owner's manual of the towed vehicle.
Rear towing eye
Fig. 194 In the rear bumper on the
right-hand side: removal of the covers for the towing eye
Fig. 195 In the rear bumper:
removal of the covers for the towing eye
First read and observe the in ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Operating ParkPilot
→ Acoustic and optical ParkPilot signals at the rear of the vehicle
The ParkPilot assists the driver when manoeuvring and parking.
The ultrasound sensors in the rear bumper transmit and recei ...
Flat Spots, Correcting
Flat spots cannot be removed from tires with workshop
equipment.
Such flat spots can be "driven out" only by driving the car
until the tires are warm.
We do not recommend the following method during ...
Cleaning seat belts
First read and observe the introductory information
and safety warningsLarge particles of dirt on the automatic belt prevent
it from rolling back properly and thus from working effectively.
The seat belts must never be removed for cleaning purposes.
Remove dirt with a soft brush .
C ...
